Charging The Battery - Palm TapWave Zodiac Using Manual

Charging the battery

Charging the battery Charging the battery Charging the battery
To use your Zodiac console, you must connect it to an AC outlet and charge
the battery.
1. Connect your console to an AC outlet using one of these three setups:
•
Desktop Setup. Connect the optional HotSync cradle (sold separately)
to the HotSync cable, your computer, and an outlet as described in the
cradle instructions, and then insert your console in the cradle.
•
Travel Setup. Connect the HotSync cable to your computer and an
outlet as described on
HotSync cable.
•
Ultra-light Setup. Connect the power adapter cable to your console.
2. Wait approximately 2 hours for the battery to fully charge.
While your console charges, the LED is yellow. When your console is fully
charged, the LED turns green.
When your console needs to be recharged, the LED blinks and turns yellow.
When the LED turns red, your battery is extremely low.
Int ro duct ion to your Zodiac Console
page
Travel Setup
13, and then connect your console to the
Ultra-light Setup
Charging the battery
Using Your Zodiac Console 14 14 14 14