Setup - Chicago Electric MIG 180 Owner's Manual

Setup

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
Note: Remove the protective foam and cardboard from the welder before setup.
Face Shield Assembly
1. Attach the handle to the Face Shield by lining
up the two rectangular tabs on the handle with
the corresponding holes in the face shield and
a. press the tabs through the holes and then
b. slide the tabs forward from the back,
locking the round tab in place.
2. Wear heavy-duty work gloves, the edges
of the filter lens may be sharp. Remove
any protective film from both sides of the
filter lens. Slide the filter lens into the Face
Shield behind the holding tabs. Make sure
that the filter lens fits securely and that
light cannot leak around its edges.
Page 8
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch off and unplug the welder before assembly.
For technical questions, please call 1-888-866-5797.
B B
A A
Face Shield
(viewed from front)
Filter Lens
Face Shield
(viewed from back)
Round
Tab
Handle
Item 62181