Setup Procedure; Connecting The Machine To A Network - Canon imageRUNNER 2545i System Settings Manual

Setup Procedure

Follow the procedure described below to set up the machine to use its functions.
IMPORTANT
• It is recommended that the network administrator perform the following procedures.
• Use the machine's control panel if you are configuring the protocol settings for the first
time. After configuring the protocol settings, you can change the content by using the
Remote UI.

Connecting the Machine to a Network

Follow the setup procedure described here to connect the machine to a TCP/IP
network.
Network Cable Connection (See Chapter 2, "Before You Start Using the
1
Machine," in the User's Guide.)
Connect the machine to the network using network cables.
2
Interface Settings (See "Interface Settings (Ethernet Driver)," on p. 2-2.)
Specify the interface settings for communication between the machine and computers on your network. To
specify the settings, use:
• The machine's control panel
• The Remote UI (via a web browser)
Communication Environment Settings (See "Communication Environment
3
Settings," on p. 2-5.)
Set up a configuration for communication between the machine and computers on your network. To specify
the settings, use:
• The machine's control panel
• The Remote UI (via a web browser)
IEEE802.1X Authentication Settings (See "IEEE802.1X Authentication
4
Settings," on p. 2-9.)
If access to your network requires authentication to a RADIUS server, specify the settings of IEEE802.1X
authentication.
1-19

Setup Procedure

1