Table of Contents
Advertisement
GETTING STARTED GUIDE
For other MIDI connection scenarios, please refer to the Forte SE Musicians Guide.
The Pedal Jacks
Use the three pedal jacks to connect controller pedals to the Forte SE.
Switch Pedals
Continuous Control
(CC) Pedals
The default function of each pedal can be changed for all Programs and Multis by setting a pedal
override on the Global Control Overrides page in Global Mode. Pedals are also independently
assignable within each Program or each Zone of every Multi.
Here are the default control settings for the five pedals used by Forte SE:
SW 1a Pedal
SW 1b Pedal
SW 2a Pedal
SW 2b Pedal
1/4 inch tip-sleeve (mono) plug or, 1/4 inch tip-ring-sleeve plug
configured as dual switches (TS and RS) or 2 terminal continuous
pedal (half-damper).
10 kΩ linear-taper potentiometer, 1/4 inch tip-ring-sleeve (stereo)
plug with the wiper connected to the tip.
Sustain (MIDI 64)
Sostenuto (MIDI 66)
Sostenuto (MIDI 66)
Soft (MIDI 67)
CC Pedal
Expression (MIDI 11)
The Rear Panel
The Pedal Jacks
5
Advertisement
Table of Contents
