Setting Up The Forte Se; Before You Start - Kurzweil Forte SE Getting Started Manual

Hide thumbs Also See for Forte SE:

Table of Contents

Don't connect anything until you make sure the Forte SE is properly and safely situated. If

your Forte SE keyboard has been out in the cold, give it time to warm up to room temperature

before starting it, since condensation may have formed inside.

Setting up the Forte SE

1. Set the keyboard on a hard, flat, level surface.

2. Four adhesive-backed rubber feet are provided with Forte SE. Carefully turn the keyboard

over onto a soft surface, remove the paper backing from the rubber feet and attach them.

3. Connect the AC power cord to the Forte SE. Before plugging the cable into the power

outlet, check that the power is compatible with the Forte SE. The Forte SE runs on AC

power and works with voltages from 80-265 volts 50-60 Hz. The voltage level is detected

and set automatically by the Forte SE. If your power source does not have the standard

three hole outlet, you should take the time to install a proper grounding system. This will

reduce the risk of a shock. If your power outlet is not within these ranges it is recommended

you use an appropriate adaptor.

4. Plug the power cable into the wall.

5. Plug the Switch Pedal into the marked SW1 (Sustain) Pedal jack on the Forte SE rear

panel.

6. Connect stereo headphones to the headphone jack on the rear panel or connect the audio

outputs to your mixer or amplifier inputs using standard (1/4-inch) audio cables (use the

Left out for mono). Balanced ("TRS" or "Stereo") cables are recommended if your mixer

or amp supports balanced inputs.

NOTE : Unless the instrument will always be used with a keyboard stand,

attachment of the rubber feet is strongly advised. Otherwise protruding

screws will scratch the tabletop.

GETTING STARTED GUIDE

Table of Contents