Yamaha DRAG STAR XVS125 Owner's Manual page 70

3
1. Locknut
2. Drive chain adjusting nut
3. Wheel axle
5. Loosen the locknut and the drive
chain adjusting nut on both ends
of the swingarm.
6. Remove the axle nut, and then
pull the wheel axle out.
7. Push the wheel forward, and
then remove the drive chain from
the rear sprocket.
NOTE:
The drive chain does not need to be
disassembled in order to remove and
install the wheel.
8. Remove the wheel.
PERIODIC MAINTENANCE AND MINOR REPAIR
To install the rear wheel
1. Insert the wheel axle from the
2 1
left-hand side, and then install
the drive chain onto the rear
sprocket.
2. Install the axle nut, and then
lower the rear wheel so that it is
on the ground.
3. Install the brake rod onto the
brake camshaft lever, and then
install the brake pedal free play
adjusting nut onto the brake rod.
4. Connect the brake torque rod to
the brake shoe plate by installing
the bolt and the nut, and then
tighten the bolt to the specified
torque.
Tightening torque:
Brake torque rod bolt:
23 Nm (2.3 m·kg)
5. Adjust the drive chain slack.
(See page 6-25 for drive chain
slack adjustment procedures.)
EAU03190
w
After adjusting the brake pedal
free play, check the operation of
the brake light.
6-40
6. Tighten the axle nut to the speci-
fied torque.
Tightening torque:
Axle nut:
104 Nm (10.4 m·kg)
7. Adjust the brake pedal position
and free play. (See page 6-20 for
brake pedal position and free
play adjustment procedures.)
1
2
3
4
EW000103
5
6
7
8
9