Rear Wheel - Yamaha DRAG STAR XVS125 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
5. Tighten the wheel axle to the
specified torque.
Tightening torque:
Wheel axle:
59 Nm (5.9 m·kg)
6. Tighten the front wheel axle
pinch bolt to the specified torque.
Tightening torque:
Front wheel axle pinch bolt:
20 Nm (2.0 m·kg)
7. Push down hard on the handle-
6
bar several times to check for
proper fork opertion.
8. Connect the speedometer cable.
1
1. Axle nut

Rear wheel

To remove the rear wheel
w
8 It is advisable to have a
Yamaha dealer service the
wheel.
8 Securely support the motorcy-
cle so that there is no danger
of it falling over.
1. Loosen the axle nut and the
brake torque rod nut at the brake
shoe plate.
6-39
3
5
1. Brake torque rod nut
2. Brake torque rod
EAU03189
3. Brake pedal free play adjusting nut
4. Brake rod
5. Brake camshaft lever
2. Lift the rear wheel off the ground
according to the procedure on
EW000122
page 6-37.
3. Disconnect the brake torque rod
from the brake shoe plate by
removing the nut and the bolt.
4. Remove the brake pedal free
play adjusting nut, and then dis-
connect the brake rod at the
brake camshaft lever.
4
2
1