Cleaning The Air Filter Element - Yamaha YBR125ED Owner's Manual

Hide thumbs Also See for YBR125ED:
Table of Contents

Advertisement

PERIODIC MAINTENANCE AND ADJUSTMENT
3
1. Engine oil drain bolt
2. Gasket
3. Oil pan
6
4. Install the engine oil drain bolt and
its new gasket, and then tighten
the bolt to the specified torque.
Tightening torque:
Engine oil drain bolt:
20 Nm (2.0 m·kgf, 14 ft·lbf)
5. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
Recommended engine oil:
See page 8-1.
Oil change quantity:
1.00 L (1.06 US qt, 0.88 Imp.qt)
NOTICE
2
1
 In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
 Make sure that no foreign mate-
rial enters the crankcase.
6. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off
and check for the cause.
7. Turn the engine off, wait a few mi-
nutes until the oil settles, and then
check the oil level and correct it if
necessary.
ECA11621

Cleaning the air filter element

The air filter element should be cleaned
at the intervals specified in the periodic
maintenance and lubrication chart.
Clean or, if necessary, replace the air
filter element more frequently if you are
riding in unusually wet or dusty areas.
1. Remove panel A. (See page 6-7.)
2. Remove the air filter case cover by
1. Screw
2. Air filter case cover
3. Remove the air filter element.
6-11
removing the screws.
EAU37124

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents