Motorola FX9500 User Manual page 72

C - 2 FX9500 RFID Reader User Guide
Lift the base off the enclosure.
5.
Remove the retaining nuts on each antenna connector.
6.
Remove the (2) retaining nut/screws on each side of the serial connector.
7.
Remove the (6) screws that are securing the board in place.
8.
Lift out the main circuit board and turn over.
9.
Locate the battery on the upper right quadrant of the board.
10.
Battery Location
Figure C-2
Use a small flat-blade screwdriver to push the battery out of the holder.
11.
Properly dispose of battery according to local and regional laws and regulations.
12.
Replace the main circuit board and install the base on the reader.
13.
Using a Torx (T15) screwdriver, install the (6) torx screws to secure the reader base to the reader
14.
enclosure.
Properly dispose of reader according to local and regional laws and regulations.
15.
Battery