Power Fault Leds; Front Drive Thermal Led; Systems Insight Display Led Combinations - HP StoreEasy 1000 Administrator's Manual

Power fault LEDs

The following table provides a list of power fault LEDs and the subsystems that are affected. Not
all power faults are used by all servers.
Subsystem
System board
Processor
Memory
Riser board PCIe slots
FlexibleLOM
Removable HPE Flexible Smart Array controller/Smart
SAS HBA controller
System board PCIe slots
Power backplane or storage backplane
Power supply

Front drive thermal LED

The thermal warning function of the front drive health/thermal LED depends on the iLO 08-HD
Max sensor reading. This function is disabled under these conditions:
There are no drives in the front drive cages 1 and 2.
The temperature sensor in one or more front drives has failed.
Under these conditions, iLO shows the 08-HD Max sensor reading as N/A. To view temperature
sensor data, log in to iLO 4 web interface and navigate to the Information→System
Information→Temperatures.
If the 08-HD Max sensor reading shows N/A, observe the following when extending the front
drive cage:
Do not keep the drive cages out of the chassis for more than 140 sec.
Keep the drive cages inside the chassis for at least 300 sec before extending them out again.

Systems Insight Display LED combinations

When the health LED on the front panel illuminates either amber or red, the server is experiencing
a health event. Combinations of illuminated Systems Insight Display LEDs, the system power
LED, and the health LED indicate system status.
Table 1 Systems Insight Display LEDs and internal health LED combinations
Systems Insight
Display LED and
color
Processor
(amber)
26 HPE StoreEasy 1000 Storage
Health LED System power
LED
Red Amber
Amber Green
LED behavior
1 flash
2 flashes
3 flashes
4 flashes
5 flashes
6 flashes
7 flashes
8 flashes
9 flashes
Status
One or more of the following conditions might exist:
Processor in socket X has failed.
Processor X is not installed in the socket.
Processor X is unsupported.
ROM detects a failed processor during POST.
Processor in socket X is in a pre-failure condition.