Table of Contents
Advertisement
Available languages
Available languages
Manual instruction | Electric Lawn Mower
upwards, then move the height adjustment lever
(12) forward or backward to your preferred cutting
height.
•
release the lower part of the height adjustment
lever until it is inserted in a slot on the height
adjustment panel (g).
Initial operation
Always use the correct supply voltage: the power
supply voltage must match the information quoted
on the tool identification plate.
Switching On and Off
Before connecting up the lawn mower to the electric
power supply, make sure that the mains supply
voltage is 230V/50Hz and being suitable for use only
in premises having a service current capacity equal
to or greater than 100A per phase with a normal
voltage of 400/230V.
Caution! Do not start the appliance if it
is standing in long grass.
Switching ON:
•
Press the safety
button (a) of the
switch box (6) and
then pull the
3
trigger lever
(b)
against
b
the
upper
part of the
6
handle (3).
•
Keep the
a
trigger lever
(b) hold while you release the safety button (a). If
you release the trigger lever (b), the motor will stop.
•
Once the motor is running, push the lawn mower
manually.
Switching OFF:
•
To stop the appliance, release the trigger lever
(b) and it automatically returns to its start position
and the motor will stop.
Instruction for use
Mowing tips
Before starting work, make sure that the
area to be cut is free of stones, debris,
EN
wires and any other objects.
•
Make sure all fasteners (screws, nuts, etc.) are
always fully tightened so that you can work safely
with the appliance.
•
Check the grass catcher for wear and tear at
regular intervals.
•
Always operate with the deflector (10) or grass
catcher (9) in the correct position.
•
Select the working depth depending upon the
state of the lawn and the actual height of the grass.
•
High grass should be cut in layers, always
beginning from the top. The recommended cutting
depth of one go is 4 cm maximum.
•
To start the appliance, the cutting device must
be completely free to move.
•
Do not cut damp or wet grass. Dry grass will give
excellent results.
•
Always let the cutting blade (k) rotate at top
speed; do not work in such a way as to overload the
appliance.
•
Never pass the appliance over the extension
attention to the cutting speed; when notice the
cutting speed is dropping or even the motor stops,
the wrong moving speed or cutting depth has been
selected.
•
Empty the grass catcher (9) once it is full in order
to prevent the blade (k) from becoming clogged
and the motor from being overload.
8
max. 20°
cable while it is running;
make sure it is always in a
safe position behind your
back. Place the extension
cord safely on a path or
the area already mowed.
•
Guide
appliance forward slowly
from the beginning, pay
the
Advertisement
Table of Contents
