Maintenance And Storage; Troubleshooting - IVT ELM-900 Operating And Safety Instructions Manual

Blade (k)
• Worn blade (k) invites poor performance and
overload of motor.
• Check the blade (k) before each use. Sharpen it
frequently (with a grind wheel) or replace the blade
(k) with a new one when necessary.
It is recommended to do this by a specialist.
• Ensure that it is always balanced (an unbalanced
blade (k) will cause dangerous vibrations). To check
for balance, insert a round rod through the central
hole and support the blade (k) horizontally. A
balanced blade (k) will remain horizontal. If the
blade (k) is not balanced the heavy end will rotate
downwards. Reshape the heavy end until the blade
(k) is currently balanced.
Caution! Disconnect the mains and wear
protective gloves.
To disassemble the blade (K):
• Hold the blade (k) with a gardening glove (not
the blade (k) out and replace it with a new one.
• The blade fixing screw (l) must be torque to
15Nm.
• When reassembling, make sure that the cutting
edges face in the direction of the motor rotation.

Maintenance and storage

Before carrying out any maintenance
operations, cut off the electric power
supply by disconnecting the plug from
the extension cable.
• Regular cleaning and maintenance of your
appliance will ensure efficiency and prolong the life
of your appliance.
Caution! Be careful during adjustment
of the appliance to prevent entrapment
of the fingers between moving blades
and fixed parts of the appliance.
included) so that
l
it could not rotate
while unscrewing
k
the blade fixing
screw (l) by turning
m
anti-clockwise the
spanner.
• Check the
condition of the fan (m),
and replace any parts,
which are damaged.
• If necessary, take
Manual instruction | Electric Lawn Mower
• Keep all nuts, bolts, and screws tight to be sure
the appliance is in safe working condition.
• Check the grass catcher (9) frequently for wear
or deterioration.
• Replace worn damaged parts for safety.
• Make sure that only replacement cutting means
of the right type are used
• After each cutting operation, take apart and
clean out the grass and soil from the ventilator and
its slot, cutting blade (k), motor housing (14) and
grass catcher (9).
• Only use a cloth soaked with hot water and a soft
brush to clean the application. Never wet or spray
water on the machine!
• Do not use detergents or solvents as these
could cause irreparable damage to your machine.
Chemicals can destroy the plastic parts.
• To protect the shredder from corrosion when
storing for a longer period, treat the cutting blade
(k) with harmless oil to the environment.
• Store the appliance in a dry room out of reach
of kids.
• To save space in storage, the upper part of the
handle (3) can be tipped upwards. Do not jam the
electric wire when pivoting!

Troubleshooting

Motor does not start
• Power supply is absent.
• The outlet is defective.
replace the outlet if necessary
• The extension cord is damaged.
cable, replace if necessary.
• The grass is too long.
height.
• The safety button has been tripped.
the engine to cool then increase the cutting speed.
Motor shuts down
• Line voltage does not correspond to the rating
on the data plate. ► Use the proper line voltage
• The extension cord is damaged.
cord is damaged.
• Internal wiring defect.
Service Center.
The machine leaves an unevenly cut path
• The cutting height is too low.
mowing height.
• The blade (k) is dulled.
• The lower part of the machine is blocked.
the machine.
9
► Check power supply.
► Try another outlet,
► Check the
► Increase the mowing
► Allow
► The extension
► Contact an authorized
► Change the
► Replace the blade (k).
►Clean
EN