Saeco Premium Operating Instructions Manual page 5

MACHINE SETTING
PRIMING THE WATER CIRCUIT
If the water in the tank is completely fi nished, you need to
prime the water circuit as explained below.
Fill the water tank. Place a container under the steam / hot water
1
wand and open the knob
slowly by turning it counter-
clockwise.
press the coff ee brew switch.
EXTRA:
2
press the manual brew button.
PREMIUM:
EXTRA
wait for a steady stream of water to come out from the
EXTRA:
3
steam / hot water wand, press the coff ee brew switch again and
close the knob. When the coff ee brew switch is steadily illumina-
ted, the machine is ready.
wait for a steady stream of water to come out from the
PREMIUM:
steam / hot water wand and for dispensing to stop automatically.
Close the knob. The two brew buttons blink during the warm-up
phase. When the two brew buttons are steadily illuminated, the ma-
chine is ready.
Remove the container used.
4
STAND-BY function
(only for Premium model): the machine au-
tomatically activates the stand-by mode after one hour of inactivity to
guarantee energy saving. This mode is signalled by the slow blinking
of the dosed co ee brew button. To turn the machine on again simply
press the blinking button.
PREMIUM
PREPARING THE COFFEE
MANUAL COFFEE BREWING
The machine is ready when the
lever is in the o position (back
position) and:
the co ee brew switch is
EXTRA:
steadily illuminated.
the brew buttons
PREMIUM:
are steadily illuminated.
Only Lavazza "A MODO MIO"
pods should be placed in the pod
compartment. Do not put your ngers or any other object in the com-
partment.
Single-dose pods brew a single co ee/product. DO NOT use the pods
more than once. Inserting 2 or more pods can cause the machine to
malfunction.
To perform the operations listed below, the steam / water knob must be
closed.
We recommend pre-warming the mug to always have co ee at ideal
temperature. Pull the loading lever forwards until it stops and without
inserting any pods. Place the mug under the dispensing spout and use
the co ee brew button/switch to dispense a su cient amount of water
to pre-warm the cup.
Place the mug/small cup under the dispen-
1
sing spout.
Lift the pod compartment
2
door, insert a pod and close
it.
Pull the loading lever for-
3
wards until it stops.
Press the coff ee brew button/switch and wait for the brewing of the
4
desired quantity.
EXTRA
Do not move the lever to the o position while co ee is brewed.
Press the coff ee brew button/
5
switch again to stop brewing
and bring the lever back to the
off position.
EN
PREMIUM