Catcher; Mulcher Insert; Cutting Height - Husqvarna LC 141LI Operator's Manual

Catcher

Assembly
Fit the catcher bag.
1 Insert the catcher bag's edging strip into the groove
around the upper cover and press on the strip to the
end.
2 Fasten the three snap fasteners around the bar of the
upper cover.
3 Attach the hooks in the upper edge of the chassis.
ASSEMBLING AND ADJUSTMENTS
Mulcher insert - Accessories
A mulching-kit is available as an accessory, to make the
machines equipped with a catcher able to be used with
mulching function. The kit contains of a mulch plug and a
blade.
1 Lift up the back shield and remove the catcher.
2 Insert the mulch plug into the collector channel.
3 Close the rear shield.
4 Replace the blade with the supplied Combi blade. For
more information, see "Cutting equipment".

Cutting height

CAUTION! Do not set the cutting height too low as there
is a risk that the cutters might hit ground with
unevenness.
The cutting height can be adjusted in 10 different steps.
• Move the lever to the back for higher cutting height
and to the front for lower cutting height.
–
English 85