General
IMPORTANT! Prevent unintentional start
!
by turning the safety key to '0', removing
the battery and waiting at least 5
seconds.
Handle
Assembly
1
Place the handlebar's tubular construction in direct
opposite to the lower part of the handlebar.
2
First, position the guide screw in the lower pipe in the
handle.
3
Then, center one of the holes for the fixing screw to
the hole in the handle.
4
Fit the screw, washer, and knob. Tighten the knobs
properly.
5
Use enclosed cable holder to secure the cable to the
handle. Do not overstretch the cable when mounting.
If the wire is tensioned too tight, damage may occur if
the handle is folded to transport position.
ASSEMBLING AND ADJUSTMENTS
Settings
Handle height
1
Loosen the lower knobs.
2
Dismantle the knob, washer, and screw.
3
Handle height can be set to 2 different positions,
4
Adjust to a suitable height with the fixing screw in one
of the two holes.
5
Fit the screw and knob.
6
Slide the knobs up towards the handle until they stop
and a click is heard. Tighten the knobs properly.
–
English
83