Housing Led Indicators - Axis Q1615-E MKII Installation Manual

AXIS Q1615-E Mk II Network Camera
• The Status LED can be configured to flash while an event is active.
• The Status LED can be configured to flash for identifying the unit. Go to Setup > System
Options > Maintenance .
Status LED
Green
Amber
Red
Note
The Network LED can be disabled so that it does not flash when there is network traffic.
To configure, go to Setup > System Options > Ports & Devices > LED. See the online
help for more information.
Network LED
Green
Amber
Unlit
Note
The Power LED can be configured to be unlit during normal operation. To configure, go
to Setup > System Options > Ports & Devices > LED. See the online help for more
information.
Power LED
Green
Amber

Housing LED Indicators

Note
The housing LED referred to in the table below is located in the housing.
Alarm events will be triggered through the camera's input port.
Indication
Steady green for normal operation.
Steady during startup. Flashes when restoring settings.
Flashes red for firmware upgrade failure.
Indication
Steady for connection to a 100 Mbit/s network. Flashes for
network activity.
Steady for connection to a 10 Mbit/s network. Flashes for
network activity.
No network connection.
Indication
Normal operation.
Flashes green/amber during firmware upgrade.
12