Adjusting Engine Speed (Subaru-Powered Units) - Miller TRAILBLAZER 275 DC Owner's Manual

8-10. Adjusting Engine Speed (Subaru-Powered Units)

4
6
5
2200 − 2300 rpm
(36.6 − 38.3 Hz)
3675 − 3750 rpm
(61.3 − 62.5 Hz)
Tools Needed:
10 mm
8 mm
2
3
.
A complete Parts List is available at www.MillerWelds.com
After tuning engine, check engine
speeds with a tachometer (see
table). If necessary, adjust speeds
as follows:
Start engine and run until warm.
Open top cover access panel to ac-
cess speed adjustments.
Idle Speed Adjustment
Move Engine Control switch to
1
Run/Idle position.
1 Throttle Solenoid
2 Mounting Screws
3 Idle Speed Screw
Loosen mounting screws. Adjust
solenoid position so engine runs at
idle speed. If necessary, back out
idle speed screw so solenoid can
be moved to correct position. Tight-
en mounting screws. Be sure sole-
noid linkage works smoothly.
Turn idle speed screw for fine
adjustments.
Weld/Power Speed Adjustment
Move Engine Control switch to Run
position.
4 Jam Nut
5 Lock Nut
6 Weld/Power Speed
Adjustment Screw
Loosen jam nut and lock nut. Turn
adjustment screw until engine runs
at weld/power speed. Tighten jam
nut, and then tighten lock nut.
!
Stop engine.
Close and secure top cover access
panel.
803 572−C
OM-4426 Page 45