Changing Engine Oil, Oil Filter, And Fuel Filter (Kohler-Powered Units) - Miller TRAILBLAZER 275 DC Owner's Manual

8-6. Changing Engine Oil, Oil Filter, And Fuel Filter (Kohler-Powered Units)

Full
Tools Needed:
.
A complete Parts List is available at www.MillerWelds.com
.
Kohler EFI Model Shown
3
4
2
1
!
Stop engine and let cool.
1 Oil Drain Valve
2 Oil Filter
Change engine oil and filter accord-
ing to engine manual.
NOTICE − Close valve and valve
cap before adding oil and running
engine.
Fill crankcase with new oil to full
mark on dipstick (see Section 5-5).
3 Secondary Fuel Filter (EFI
Models Only)
4 Primary Fuel Filter
5 Fuel Line
Replace line if cracked or worn.
Install new filter. Wipe up any spilled
fuel.
Start engine, and check for fuel
leaks.
!
Stop engine, tighten connec-
tions as necessary, and wipe
up fuel.
Reset oil maintenance countdown
by leaving the engine off and flip-
ping Engine Control switch from
Run/Idle to Run three times.
3 or 4
5
246 198−A / S-0842
OM-4426 Page 41