Remote Receptacle Information - Miller TRAILBLAZER 275 DC Owner's Manual

.
A complete Parts List is available at www.MillerWelds.com

5-12. Remote Receptacle Information

.
Engine runs at weld/power speed whenever a device connected to the remote receptacle is running.
A J
K
I
B
C L N
H
M
D G
F
E
*The remaining sockets are not used.
Notes
OM-4426 Page 28
24 VOLTS AC
115 VOLTS AC
REMOTE
OUTPUT
CONTROL
803 571
GND
Socket* Socket Information
A 24 volts ac. Protected by supplementary protector
CB4.
B Contact closure to A completes 24 volt AC con-
tactor control circuit and keeps engine at Run
speed in all Wire modes.
I 115 volts ac. Protected by supplementary protec-
tor CB3.
J Contact closure to I completes 115 volts AC con-
tactor control circuit.
C +10 volts dc output to remote control.
D Remote control circuit common.
E 0 to +10 volts dc input command signal from
remote control.
F Current feedback: 1 volt per 100 amperes.
H Voltage feedback: 1 volt per 10 arc volts.
G Circuit common for 24 and 115 volts AC circuits.
K Chassis common.
Work like a Pro!
Pros weld and cut
safely. Read the
safety rules at
the beginning
of this manual.