Lubrication; Battery Care - Yamaha F100D Owner's Manual

8. Drain the remained gasoline in the vapor
separator with a container. Loosen the
drain screw, and then remove the cap.
Push in the air valve with a screwdriver to
introduce air into the float chamber, so
that the gasoline will drain smoothly.
Then, tighten the drain screw.
1. Vapor separator
2. Drain screw
3. Cap
1. Air valve
9. Remove the flushing attachment.
10. Install the top cowling.
11. If "Fogging Oil" is not available, turn off
the engine after the 6 step. Then perform
the 8 step procedure.
12. Drain the cooling water completely out of
the motor. Clean the body thoroughly.
13. If the "Fogging Oil" is not available, re-
move the spark plug(s). Pour a teaspoon-
ful of clean engine oil into each cylinder.
Crank several times manually. Replace
the spark plug(s).
NOTE:
A flushing attachment is available from your
Yamaha dealer.
EMU28401

Lubrication

1. Grease the spark plug threads and install
the spark plug(s) and torque to proper
specification. For information on spark
plug installation, see page 52.
2. Change the gear oil. For instructions, see
page 58. Inspect the oil for the presence
of water that indicates a leaky seal. Seal
replacement should be performed by an
authorized Yamaha dealer prior to use.
3. Grease all grease fittings. For further de-
tails, see page 52.
EMU28430

Battery care

EWM00330
WARNING
Battery electrolytic fluid is dangerous; it
contains sulfuric acid and therefore is poi-
sonous and highly caustic.
Always follow these preventive measures:
Avoid bodily contact with electrolytic
G
fluid as it can cause severe burns or per-
manent eye injury.
Wear protective eye gear when handling
G
or working near batteries.
Antidote (EXTERNAL):
SKIN - Flush with water.
G
EYES - Flush with water for 15 minutes
G
and get immediate medical attention.
Antidote (INTERNAL):
Maintenance
47