Trim Tab With Anode; Tilt Support Lever For Power Trim And Tilt Or Hydro Tilt Model - Yamaha F100D Owner's Manual

Basic components
If the trolling speed has been adjusted, the
G
engine returns to the normal trolling speed
when the engine is stopped and restarted
or when the engine speed exceeds approx-
imately 3000 r/min.
For instructions on using the variable troll-
G
ing RPM switches, see page 36.
1. Variable trolling RPM switch
EMU26241

Trim tab with anode

The trim tab should be adjusted so that the
steering control can be turned to either the
right or left by applying the same amount of
force.
EWM00840
WARNING
An improperly adjusted trim tab could
cause difficult steering. Always test run af-
ter the trim tab has been installed or re-
placed to be sure steering is correct. Be
sure you have tightened the bolt after ad-
justing the trim tab.
If the boat tends to veer the left (port side),
turn the trim tab rear end to the port side "A" in
the figure. If the boat tends to veer the right
(starboard side), turn the trim tab end to the
starboard side "B" in the figure.
14
ECM00840
CAUTION:
The trim tab also serves as an anode to
protect the engine from electrochemical
corrosion. Never paint the trim tab as it will
become ineffective as an anode.
1
1. Trim tab
2. Bolt
3. Cap
EMU26340
Tilt support lever for power trim and
tilt or hydro tilt model
To keep the outboard motor in the tilted up po-
sition, lock the tilt support lever to the clamp
bracket.
3
2
B
A
ZMU02525
A
B
ZMU01863