Yamaha XJR1300 Owner's Manual page 50

PERIODIC MAINTENANCE AND MINOR REPAIR
2. Place an oil pan under the engine
to collect the used oil.
3. Remove the engine oil filler cap
and drain bolt to drain the oil from
the crankcase.
1. Engine oil drain bolt
6
NOTE:
Skip steps 4–10 if the oil filter element
is not being replaced.
4. Remove panel C. (See page 6-5.)
5. Remove the oil filter element drain
screw to drain the oil from the oil fil-
ter element.
6. Remove the oil filter element cover
by removing the bolt.
1. Oil filter element drain screw
2. Bolt
3. Oil filter element cover
7. Remove and replace the oil filter
element and O-ring.
1. Oil filter element
2. O-ring
6-9
8. Install the oil filter element cover by
aligning the projection on the cover
with the slot in the crankcase, in-
stalling the bolt, then tightening it
to the specified torque.
1. Projection
2. Slot
Tightening torque:
Oil filter element cover bolt:
15 Nm (1.5 m·kgf, 11 ft·lbf)
NOTE:
Make sure that the O-ring is properly
seated.
9. Install the oil filter element drain
screw, and then tighten it to the
specified torque.