Yamaha XJR1300 Owner's Manual page 22

INSTRUMENT AND CONTROL FUNCTIONS
Right
3
1. Engine stop switch "
2. Start switch " "
Pass switch "PASS"
Press this switch to flash the headlight.
Dimmer switch "
Set this switch to "
beam and to " " for the low beam.
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
the engine. Set this switch to "
/ "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
EAU12360
or when the throttle cable is stuck.
Start switch "
EAU12400
Push this switch to crank the engine
/ "
with the starter.
" for the high
CAUTION:
See page 5-1 for starting instruc-
EAU12460
/ "
tions prior to starting the engine.
". When re-
Hazard switch "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard light (simultaneous flashing of all
EAU12500
" turn signal lights).
The hazard light is used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
EAU12660
/ "
might be a traffic hazard.
" before starting
" to
CAUTION:
Do not use the hazard light for an ex-
tended length of time, otherwise the
battery may discharge.
EAU12710
"
ECA10050
3-8
EAU12731
"
" posi-
ECA10060