Yamaha FJR1300A Owner's Manual page 39

Right
1
2
3
1. Start/Engine stop switch "
2. Drive mode switch "MODE"
3. Hazard switch " "
Dimmer/Pass switch "
Set this switch to " " for the high
beam and to " " for the low beam.
To flash the high beam, push the pass
side "PASS" of the switch while the
headlights are on low beam.
Turn signal switch " /
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
INSTRUMENT AND CONTROL FUNCTIONS
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Start/Engine stop switch "
To crank the engine with the starter,
set this switch to "
/ / "
the " " side of the switch. See page
5-1 for starting instructions prior to
starting the engine.
EAU54201
Set this switch to "
/ /PASS"
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
The engine trouble warning light will
come on when the key is turned to
EAU12461
"ON" and the start switch is pushed,
"
but this does not indicate a malfunc-
tion.
". When
Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
EAU12501
" turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
EAU54211 when your vehicle is stopped where it
/ / "
might be a traffic hazard.
", and then push
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
" to stop the en-
tery may discharge.
Cruise control switches
See page 3-6 for an explanation of the
EAU41701
cruise control system.
Menu switch "MENU"
This switch is used to perform selec-
tions in the function display and setting
mode display of the multi-function me-
ter unit.
See "Multi-function meter unit" on
page 3-10 for detailed information.
3-24
EAU12735
" posi-
3
ECA10062
EAU12781
EAU54231