Yamaha FJR1300A Owner's Manual page 30

INSTRUMENT AND CONTROL FUNCTIONS
TIP
 –9 °C will be displayed even if the
ambient temperature falls below
–9 °C.
 50 °C will be displayed even if the
3
ambient temperature
above 50 °C.
 The accuracy of the temperature
reading may be affected when rid-
ing slowly [approximately under
20 km/h (12.5 mi/h)] or when
stopped at traffic signals, railroad
crossings, etc.
Coolant temperature display:
C.TEMP
The coolant temperature display indi-
cates the temperature of the coolant.
The coolant temperature varies with
changes in the weather and engine
load.
If the message "Hi" flashes, stop the
vehicle, then stop the engine, and let
the engine cool. (See page 6-38.)
climbs
TIP
The selected information display can-
not be switched while the message
"Hi" is flashing.
NOTICE
˚C
Do not continue to operate the en-
Lo
gine if it is overheating.
Average fuel consumption display:
FUEL AVG
GEAR
4
C.TEMP ˚C
Hi
ECA10022
km/L
12.3
3-15
The average fuel consumption display
modes "km/L", "L/100km" or "MPG"
(for the UK only) show the average fuel
consumption since the display was last
reset.
 The "km/L" display shows the av-
erage distance that can be trav-
eled on 1.0 L of fuel.
 The "L/100km" display shows the
average amount of fuel necessary
to travel 100 km.
 For the UK only: The "MPG" dis-
play shows the average distance
that can be traveled
1.0 Imp.gal of fuel.
To reset the average fuel consumption
display, use the select switch to select
the information display that contains
the average fuel consumption display.
Push the "RESET" button briefly so
that the average fuel consumption dis-
play flashes, and then push the "RE-
SET" button again for at least 2
seconds while the display is flashing.
on