Adjusting The Shock Absorber Assembly - Yamaha FZ1-S Owner's Manual

Rebound damping setting:
Minimum (soft):
26 click(s) in direction (b)*
Standard:
18 click(s) in direction (b)*
Maximum (hard):
1 click(s) in direction (b)*
* With the adjusting screw fully turned
in direction (a)
Compression damping force
1. Compression damping force adjusting screw
The compression damping force is ad-
justed on the left front fork leg only. To
increase the compression damping
force and thereby harden the compres-
sion damping, turn the adjusting screw
in direction (a). To decrease the com-
INSTRUMENT AND CONTROL FUNCTIONS
pression damping force and thereby
soften the compression damping, turn
the adjusting screw in direction (b).
TIP
Be sure to perform this adjustment on
the left front fork leg.
Compression damping setting:
Minimum (soft):
26 click(s) in direction (b)*
Standard:
5 click(s) in direction (b)*
Maximum (hard):
1 click(s) in direction (b)*
* With the adjusting screw fully turned
in direction (a)
TIP
Although the total number of clicks of a
damping force adjusting mechanism
may not exactly match the above spec-
ifications due to small differences in
production, the actual number of clicks
always represents the entire adjusting
range. To obtain a precise adjustment,
it would be advisable to check the num-
ber of clicks of each damping force ad-
justing mechanism and to modify the
specifications as necessary.
3-23
Adjusting the shock absorber
assembly
This shock absorber assembly is
equipped with a spring preload adjust-
ing ring and a rebound damping force
adjusting screw.
NOTICE
To avoid damaging the mechanism,
do not attempt to turn beyond the
maximum or minimum settings.
Spring preload
1 2 3
(b)
(a)
1. Spring preload adjusting ring
2. Special wrench
3. Extension bar
4. Position indicator
EAU39344
ECA10101
3
4
5 6 7
1 2 3 4