Yamaha FZ1-S Owner's Manual page 86

PERIODIC MAINTENANCE AND ADJUSTMENT
G
The drive chain cannot be disas-
sembled.
7. While supporting the brake caliper
bracket, pull the wheel axle out,
and then remove the wheel.
NOTICE: Do not apply the brake
after the wheel has been re-
moved together with the brake
disc, otherwise the brake pads
will be forced shut.
6
1. Wheel axle
To install the rear wheel
1. Install the wheel and the brake cal-
iper bracket by inserting the wheel
axle from the left-hand side.
TIP
G
Make sure that the slot in the brake
caliper bracket is fit over the retain-
er on the swingarm.
G Make sure that there is enough
space between the brake pads be-
fore installing the wheel.
[ECA11071]
1. Slot
2. Retainer
2. Install the drive chain onto the rear
sprocket.
3. Install the axle nut.
EAU48401
4. Take the vehicle off the center-
stand so that the rear wheel is on
the ground, and then put the side-
stand down.
5. Adjust the drive chain slack. (See
page 6-23.)
6. Tighten the axle nut to the speci-
6-38
fied torque.
Tightening torque:
Axle nut:
150 Nm (15.0 m·kgf, 110 ft·lbf)