Yamaha CRYPTON T110C Owner's Manual page 67

5
4
3
1. Washer
2. Axle nut
3. Brake rod
4. Brake pedal free play adjusting nut
5. Brake camshaft lever
7. Remove the axle nut and the
washer, and then pull the wheel
axle out.
1
1. Wheel axle
PERIODIC MAINTENANCE AND ADJUSTMENT
8. Push the wheel forward, and then
remove the drive chain from the
1
2
rear sprocket.
TIP
The drive chain does not need to be
disassembled in order to remove and
install the wheel.
9. Remove the wheel.
To install the rear wheel
1. Install the wheel by inserting the
wheel axle from the left-hand side.
2. Install the drive chain onto the rear
sprocket.
3. Install the washer and the axle nut.
4. Install the brake rod onto the brake
camshaft lever, and then install the
brake pedal free play adjusting nut
onto the brake rod.
5. Connect the brake torque rod to
the brake shoe plate by installing
the bolt, the washer and the nut.
6. Adjust the drive chain slack. (See
page 6-20.)
7. Tighten the brake torque rod nut
and axle nut to the specified
torques.
TIP
When tightening the axle nut, hold the
wheel axle with a wrench to keep it from
turning.
EAU47702
8. Insert a new cotter pin.
9. Adjust the brake pedal free play.
10. Install the drive chain case by in-
6-36
Tightening torques:
Brake torque rod nut:
19 Nm (1.9 m·kgf, 14 ft·lbf)
Axle nut:
60 Nm (6.0 m·kgf, 43 ft·lbf)
(See page 6-17.) WARNING! Af-
ter adjusting the brake pedal
free play, check the operation of
the brake light.
[EWA16080]
stalling the bolts.
6