Yamaha GRIZZLY 450 YFM450DF Owner's Manual page 109

Table of Contents

Advertisement

TIP
If the engine was started before checking the oil
level, be sure to warm up the engine sufficiently,
and then wait at least ten minutes until the oil set-
tles for an accurate reading.
4. Remove the engine oil filler cap, and then
wipe the engine oil dipstick off with a clean
rag.
1. Engine oil filler cap
5. Insert the dipstick into the filler hole (without
screwing it in), and then remove it again to
check the oil level.
TIP
The engine oil should be between the tip of the
dipstick and the maximum level mark.
1. Engine oil dipstick
2. Maximum level mark
3. Tip of the engine oil dipstick
6. If the engine oil is not between the tip of the
dipstick and the maximum level mark, add
sufficient oil of the recommended type to
raise it to the correct level. NOTICE: Be sure
the engine oil is at the correct level, other-
wise engine damage may result.
7. Insert the dipstick into the oil filler hole, and
then tighten the engine oil filler cap.
8-17
8
[ECB00852]

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Grizzly 450 yfm450pfGrizzly 450 yfm450phf

Table of Contents