Yamaha GRIZZLY 450 YFM450DF Owner's Manual page 105

1
1. Quick fastener screw
2. Panel B
To install the panel
1. Place the panel in the original position, and
then install the quick fastener screws.
2. Place the carrier in the original position, and
then install the carrier bolts under the fenders.
3. Install the carrier top bolts, and then tighten
all bolts to the specified torques.
Tightening torques:
Carrier bolt (top):
34 Nm (3.4 m·kgf, 25 ft·lbf)
Carrier bolt (under fenders):
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
Panel D
To remove the panel
Remove the bolts, and then take the panel off.
2
1. Panel D
2. Bolt
To install the panel
Place the panel in the original position and install
the bolts.
Panel E
To remove the panel
Pull outward on the areas shown.
8-13
1
2
8