Denon DRA-F101 Operating Instructions Manual page 14

ENGLISH
(2) Presetting AM and FM stations
Example: To preset the currently tuned in FM station at preset number "3"
1, 3 2
MEMORY TUNING SOURCE
FUNCTION TONE TIMER DISPLAY / SET DOWN UP BAND DIRECT
SYSTEM
ON / STANDBY
PHONES
Press the MEMORY/SET button.
• The "P.SET", "MEMO"
indicator flashes.
• Depending on what preset number is
displayed before the button is pressed, the
preset number section flashes as shown
below and the setting standby mode is set.
1
When "01" to "10" or "0-" is displayed,
"0-" flashes.
When "11" to "20" or "1-" is displayed,
"1-" flashes.
When "21" to "30" or "2-" is displayed,
"2-" flashes.
When "31" to "40" or "3-" is displayed,
"3-" flashes.
TUNING
While the "MEMO" indicator
DOWN
is flashing, press the TUNING
UP button three times to
display "P.SET", "03".
2
To store the station at a different preset
number, use the tuning buttons (TUNING UP
or DOWN) to set the desired preset number.
Press the MEMORY/SET button
again while the "MEMO"
3
indicator is flashing.
• The "MEMO" indicator turns
off and the station is preset.
A total of 40 AM and FM stations can be preset
using this procedure.
14
When operating with the
system remote control unit,
first set the remote control
VOLUME
unit's function selector switch
to "TUNER".
AM-FM STEREO RECEIVER DRA-F101 Procedure
MEMORY
/ SET
3
/
MEMORY
/ SET
DRA-F101 (RC-927)
(this unit)
• This setting can also be made by pressing the
TUNING
button instead of pressing "e".
• To store the station at a different preset number,
use the number buttons and the +10 button on the
system remote control unit (RC-927) to set the
desired preset number.
Examples:
To store the station at preset number 12:
Press +10 , 2
To store the station at preset number 29:
Press +10 , +10 , 9
UP
Presetting
• When a station is preset, both the reception
frequency and reception mode are stored in the
memory.
• If a station is preset at a number where another
station is already preset, the previous station is
erased and the new station is set.
• The preset memory is not erased immediately if the
power supply is cut off momentarily.
MEMORY
/ SET
(3) Tuning in Preset Stations
Example: To tune in the station stored at preset
number "3"
CD When operating with the
TUNER
MD
system remote control unit,
TAPE
first set the remote control
unit's function selector switch
to "TUNER".
(RC-927)
Procedure:
MEMORY
/ SET • Instead of pressing e, the preset
/
channel can also be called out by
pressing the < or > button to display
DRA-F101
"P.SET 03".
(this unit)
• To call the station at a different preset number, use
the number buttons and the +10 button on the
system remote control unit (RC-927) to set the
desired preset number.
Examples:
To call the station at preset number 12:
Press +10 , 2
To call the station at preset number 29:
Press +10 , +10 , 9
CD
TUNER
MD
TAPE
(RC-927)
3