Error Message "E06" Appears In The Lcd - Baby Lock PRESTO Instruction And Reference Manual

d Hold the thread end with your left hand, and wind off
the thread clockwise with your right hand as shown
below.
e Wind the bobbin again.
Note
• Make sure that the thread passes under the
pretension disk of the bobbin-winding thread
guide correctly.

Error message "E06" appears in the LCD

If the error message "E06" appears in the LCD with the
occurrence of one of the following symptoms, follow the
procedure below to solve the problem.
■ Symptoms
• Symptom 1: The machine rattles and then stops just
after sewing is started.
• Symptom 2: The upper thread is tangled, for
example, in the race, or fabric is caught in the
machine.
• Symptom 3: The needle breaks, or the needle bends
and thus hits the needle plate.
• Symptom 4: The fabric does not feed.
■ Symptom 1: The machine rattles and then stops
just after sewing is started.
Cause
• The upper thread is not threaded correctly.
• The thread take-up lever is not threaded.
• When the machine stops just after sewing is started,
the upper thread may not be threaded correctly.
Note
• If the needle is not raised, the upper thread
cannot be threaded correctly. Be sure to press
(Needle position button) to raise the needle
before threading the upper thread.
Remedy
Thread the upper thread again correctly by following the
procedure below.
a Turn off the machine.
b If the thread is tangled, remove the tangled thread.
• Refer to "Cleaning the race" on page A-2 and
"Tangled thread on wrong side of fabric" on page A-
5.
c Remove the upper thread from the machine.
d Turn the handwheel toward you (counterclockwise) to
check if the handwheel moves smoothly.
If the handwheel moves smoothly
If the handwheel does not move
smoothly
e Remove the needle plate cover, and then remove the
bobbin and bobbin case.
f Insert the bobbin case so that the
bobbin case aligns with the
• Refer to "Cleaning the race" on page A-2.
g Attach the needle plate cover.
• Refer to "Cleaning the race" on page A-2.
Troubleshooting
A
j
Continue with step .
e
Continue with step .
mark on the
mark on the machine.
Appendix A-11