Table of Contents
Advertisement
MAKE SURE YOU HAVE RECEIVED ALL PARTS:
Check your packing list to verify that all listed parts have been received. You should have the following:
• Unvented gas log grate/burner assembly
• Installation/operating instructions
• Ceramic Fiber logs
The milli-volt controlled version of this heater is the only style designed to be operated with optional devices for
ON/OFF functions. The following options may be used with the millivolt controlled heater. These options are not
packaged with the log set.
• Hand held Remote with receiver
• Wall switch with 15' wire
• Handle the gas log burner assembly by the grate only. Do not pick the unit
up by the burners.
• Gloves are recommended when handling ceramic fiber logs to prevent skin
irritation from loose fibers. Logs are fragile — handle with care.
Carefully inspect the contents for shipping damage. If any parts are missing or damaged, immediately inform the
dealer from whom you purchased the appliance. Do not attempt to install any part of the appliance unless you
have all parts in good condition.
WHAT YOU WILL NEED FOR INSTALLATION:
You must have the following items available before proceeding with installation:
• External regulator (for propane/LPG and 1/2 lb. or greater, natural gas systems)
• Piping which complies with local codes
• Screwdriver
• Pipe sealant approved for use with propane/LPG (Resistant to sulfur compounds)
• Drill with 5/32 bit
• Manual shutoff valve
43D0122
• Plastic bag containing crushed volcanic rock
• Four (4) anchoring screws
• Four (4) self-tapping screws
• Wall thermostat with 15' wire
• Hand held Thermostat Remote with receiver
• Sediment trap
• Tee joint.
• Pipe wrench or appropriate size crescent wrench set
GETTING STARTED
5
Hide quick links:
Advertisement
Table of Contents
