Yamaha WOLVERINE 450 YFM45FXY Owner's Manual page 24

EBU18100
Start switch " "
Push this switch to crank the engine with the start-
er.
ECB00050
NOTICE
See the starting instructions on page 6-1 prior
to starting the engine.
4
EBU18151
Light switch "
Set this switch to "
and the taillight. Set the switch to "
the high beams and the taillight. Set the switch to
"OFF" to turn off all the lights.
ECB00040
NOTICE
Do not use the headlights with the engine
turned off for an extended period of time, oth-
erwise the battery may discharge to the point
that the starter motor will not operate properly.
If this should happen, remove the battery and
recharge it.
/ /OFF"
" to turn on the low beams
" to turn on
EBU28221
On-Command four-wheel-drive switch
"2WD"/"4WD"
This ATV is equipped with a switch to change from
two-wheel drive to four-wheel drive and vice versa.
Select the appropriate drive according to the ter-
rain and the conditions.
G
"2WD" (two-wheel drive): Power is supplied to
the rear wheels.
G
"4WD" (four-wheel drive): Power is supplied to
the rear and front wheels.
To change from two-wheel drive to four-wheel
drive, stop the ATV and push the switch in to the
"4WD" position.
indicator " " comes on in the speedometer unit
display.
To change from four-wheel drive to two-wheel
drive, stop the ATV and push the switch in to the
"2WD" position.
4-5
Then, the four-wheel-drive