Water Separator-Alert Indicator Blinks While Cruising - Yamaha F100D Owner's Manual

Trouble Recovery
1
1. Manual valve screw
2. Put the engine in the desired position,
then tighten the manual valve screw by
turning it clockwise.
EMU37581
Water separator-alert indicator blinks
while cruising
EWM01501
WARNING
Gasoline is highly flammable, and its va-
pors are flammable and explosive.
 Do not perform this procedure on a hot
or running engine. Allow the engine to
cool.
 There will be fuel in the fuel filter. Keep
away from sparks, cigarettes, flames or
other sources of ignition.
 This procedure will allow some fuel to
spill. Catch fuel in a rag. Wipe up any
spilled fuel immediately.
 The fuel filter must be reassembled
carefully with the O-ring, filter cup, and
hoses in place. Improper assembly or
replacement could result in a fuel leak,
which could result in a fire or explosion
hazard.
If the water separator-alert indicator on the
6Y8 Multifunction tachometer blinks, perform
the following procedure.
84
1
ZMU04249
1. Water separator-alert indicator
1. Stop the engine.
2. Remove the top cowling.
3. Remove the plastic tie.
1. Plastic tie
4. Disconnect the water detection switch
coupler. NOTICE: Be careful not to get
any water on the water detection
switch coupler, otherwise a malfunc-
tion could occur.
1
ZMU05442
[ECM01951]