Removing Propeller; Installing Propeller - Yamaha F100D Owner's Manual

Maintenance
 Check each of the propeller blades for ero-
sion from cavitation or ventilation, or other
damage.
 Check the propeller shaft for damage.
 Check the splines for wear or damage.
 Check for fish line tangled around the pro-
peller shaft.
 Check the propeller shaft oil seal for dam-
age.
EMU30663

Removing propeller

EMU29198
Spline models
1. Straighten the cotter pin and pull it out
using a pair of pliers.
2. Remove the propeller nut, washer, and
spacer (if equipped). WARNING! Do not
use your hand to hold the propeller
when loosening the propeller nut.
[EWM01891]
1. Cotter pin
2. Propeller nut
3. Washer
74
1
3
6
2
4
5
ZMU03228
4. Spacer
5. Propeller
6. Thrust washer
3. Remove the
equipped), and thrust washer.
EMU30673

Installing propeller

EMU29235
Spline models
ECM00502
NOTICE
Make sure to use a new cotter pin and
bend the ends over securely. Otherwise,
the propeller could come off during oper-
ation and be lost.
1. Apply Yamaha marine grease or a corro-
sion resistant grease to the propeller
shaft.
2. Install the spacer (if equipped), thrust
washer, washer (if equipped), and pro-
peller on the propeller shaft. NOTICE:
Make sure to install the thrust washer
before installing the propeller. Other-
wise, the lower case and propeller
boss could be damaged.
3. Install the spacer (if equipped) and the
washer. Tighten the propeller nut to the
specified torque.
Propeller nut tightening torque:
34 Nm (3.47 kgf-m, 25.1 ft-lb)
4. Align the propeller nut with the propeller
shaft hole. Insert a new cotter pin in the
hole and bend the cotter pin ends.
NOTICE: Do not reuse the cotter pin.
Otherwise, the propeller can come off
during operation.
propeller, washer
[ECM01882]
[ECM01892]
(if