Water Separator-Alert Indicator Blinks While Cruising - Yamaha F40G Owner's Manual

Trouble Recovery
ing it counterclockwise until it stops.
1
1. Manual valve screw
2. Put the engine in the desired position,
then tighten the manual valve screw by
turning it clockwise.
EMU41470
Water separator-alert indicator blinks
while cruising
EWM01500
WARNING
Gasoline is highly flammable, and its va-
pors are flammable and explosive.
Do not perform this procedure on a hot

or running engine. Allow the engine to
cool.
There will be fuel in the fuel filter. Keep

away from sparks, cigarettes, flames or
other sources of ignition.
This procedure will allow some fuel to

spill. Catch fuel in a rag. Wipe up any
spilled fuel immediately.
The fuel filter must be reassembled

carefully with the O-ring, filter cup, and
hoses in place. Improper assembly or
replacement could result in a fuel leak,
which could result in a fire or explosion
hazard.
If the water separator-alert indicator on the
6Y8 Multifunction tachometer blinks, perform
98
the following procedure.
ZMU03668
1. Water separator-alert indicator
F40D, F50F, FT50G, F60C, FT60D
1. Stop the engine.
2. Remove the top cowling.
3. Remove the plastic tie.
1. Plastic tie
4. Disconnect the water detection switch
coupler. NOTICE: Be careful not to get
any water on the water detection
switch coupler, otherwise a malfunc-
tion could occur.
1
[ECM01950]
ZMU05475