PERIODIC MAINTENANCE AND ADJUSTMENT
TIP
Using the alignment marks on each
side of the swingarm, make sure that
both belt pullers are in the same posi-
1
tion for proper wheel alignment.
4. Tighten the locknuts and the axle
2
nut to their specified torques.
3
Tightening torques:
Locknut:
15.5 Nm (1.6 m·kgf, 11 ft·lbf)
4
Axle nut:
150 Nm (15.0 m·kgf, 108 ft·lbf)
5
6
7
8
9
Checking and lubricating the
cables
The operation of all control cables and
the condition of the cables should be
checked before each ride, and the ca-
bles and cable ends should be lubricat-
ed if necessary. If a cable is damaged
or does not move smoothly, have a
Yamaha dealer check or replace it.
WARNING! Damage to the outer
sheath may interfere with proper ca-
ble operation and will cause the in-
ner
cable
to
rust.
damaged cable as soon as possible
to prevent unsafe conditions.
Recommended lubricant:
Engine oil
6-20
EAU23101
Checking and lubricating the
throttle grip and cable
The operation of the throttle grip should
be checked before each ride. In addi-
tion, the cable should be lubricated at
the intervals specified in the periodic
maintenance chart.
Replace
a
[EWA10721]
EAU23111