Adjusting Trim Angle - Yamaha F6A Owner's Manual

ADJUSTING TRIM ANGLE

EMU00951
Manual tilt model
There are 4 or 5 holes provided in the clamp
bracket to adjust the outboard motor trim
angle.
1) Stop the engine.
2) Remove the trim angle adjusting rod 1
from the clamp bracket while tilting the
motor up slightly.
3) Reposition the rod in the desired hole.
To raise the bow ("trim-out"), move the rod
away from the transom.
To lower the bow ("trim-in"), move the rod
toward the transom.
Make test runs with the trim set to different
angles to find the position that works best for
your boat and operating conditions.
WARNING
@
G Stop the engine before adjusting the
trim angle.
G
Use care to avoid being pinched when
removing or installing the rod.
G
Use caution when trying a trim posi-
tion for the first time. Increase speed
gradually and watch for any signs of
instability
Improper trim angle can cause loss of
control.
@
NOTE:
@
The outboard motor trim angle can be
changed approximately 4 degrees by shift-
ing the trim adjusting-rod one hole.
@
3-43
or control problems.
GB