Engine Oil - Yamaha BIG BEAR YFM400FPR Owner's Manual

1. Oil filler cap
1. Bouchon de remplissage d'huile
1. Tapa del orificio de llenado de aceite
1. Dipstick
3. Minimum level mark
1. Jauge
3. Repère de niveau minimum
1. Varilla
3. Marca de nivel minimo
2. Maximum level mark
2. Repère de niveau maximum
2. Marca de nivel máximo

Engine oil

Engine oil level measurement
1. Place the ATV on a level surface.
2. Warm up the engine for several minutes, and
then stop it.
3. Remove the engine oil filler cap and wipe off
the dipstick with a clean rag. Insert the dip-
stick in the filler hole without screwing it in.
NOTE:
_
Wait a few minutes until the oil level settles before
checking.
_
4. Remove the dipstick and check the oil level.
5. The oil level should be between the maxi-
mum and minimum level marks. If the engine
oil is below the minimum level mark, add the
specified amount of the specified engine oil to
raise it to the specified level.
CAUTION:
_
Make sure that no foreign material enters the
crankcase.
_
8-13
EBU01233