Starting The Engine; Using The Self-Propel Drive; Stopping The Engine - Toro 20658 Operator's Manual

Starting the Engine

1. Push the ignition toggle switch to the On ("I")
position (Figure 13).
1. Ignition toggle switch
2. Pull the recoil start handle (Figure 14).
Note: If the mower does not start, contact an
Authorized Service Dealer.
Figure 13
Figure 14

Using the Self-propel Drive

To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your
sides, and the mower will automatically keep pace with
you (Figure 15).

Stopping the Engine

Service Interval: Before each use or daily—Ensure that
the engine stops within 3 seconds
after releasing the blade control bar.
1. Push the ignition toggle switch to the Stop position
(Figure 16).
1. Ignition toggle switch
2. When the engine stops, remove the ignition key
when you leave the mower.
Important: When you release the blade control
bar, the blade should stop within 3 seconds. If
they do not stop properly, stop using your mower
immediately and contact an Authorized Service
Dealer.
9
Figure 15
Figure 16