Before Operating - Toro 03530 Operator's Manual

Maintenance
Figure 46
1. Hydraulic Reservoir
REPLACING THE HYDRAULIC
FILTER
The hydraulic system filter head is equipped with a
service interval indicator. With the engine running,
view the indicator; it should be in the GREEN zone.
When the indicator is in the RED zone, the filter ele-
ment should be changed. Use the Toro replacement
filter (Part No. 75-1310).
IMPORTANT: Use of any other filter may void
the warranty on some components.
CHECKING HYDRAULIC LINES
AND HOSES
Daily, check hydraulic lines and hoses for leaks,
kinked lines, loose mounting supports, wear, loose
fittings, weather deterioration and chemical deterio-
ration. Make all necessary repairs before operating.
34
WARNING
Keep your body and hands away from pin-hole leaks
or nozzles that eject high-pressure hydraulic fluid.
Use cardboard or paper to find hydraulic leaks.
Hydraulic fluid escaping under pressure can pene-
trate skin and cause injury. Fluid accidentally inject-
ed into the skin must be surgically removed within a
few hours by a doctor familiar with this form of
injury or gangrene may result.
ADJUSTING THE TRACTION
DRIVE FOR NEUTRAL
The machine must not creep when traction pedal is
released. If it does creep, an adjustment is required.
1. Park the machine on a level surface, shut the
engine off and lower the cutting units to the
floor. Depress only the right brake pedal and
engage the parking brake.
2. Jack up the left side of the machine until the
front tire is off the shop floor. Support the
machine with jack stands to prevent it from
falling accidentally.
3. Under the right side of the machine, loosen the
locknut on the traction adjustment cam.
1. Traction Adjustment Cam
Figure 47