Before Operating; Check The Cooling System - Toro 03530 Operator's Manual

Before Operating

CHECK THE ENGINE OIL
1. Park the machine on a level surface. Open the
hood.
2. Remove the dipstick, wipe it clean, then reinstall
it. Remove it again and check the oil level on
the dipstick; The oil level should be up to the
FULL mark.
1. Dipstick
3. If the oil is below the FULL mark, remove the
fill cap and add SAE 10W-30 CD classification
oil until the level reaches the FULL mark on the
dipstick. DO NOT OVERFILL. Crankcase
capacity is 3.8 l with filter.
1. Oil Fill Cap
4. Install the oil fill cap and close the hood.

CHECK THE COOLING SYSTEM

Clean debris from the screen, oil cooler and the front
Figure 1
Figure 2
of the radiator daily, more often if conditions are
extremely dusty and dirty.
The cooling system is filled with a 50/50 solution of
water and permanent ethylene glycol anti-freeze.
Check the level of coolant in the expansion tank each
day before starting the engine. Cooling system
capacity is 9.6 l.
1. Check the level of coolant in the expansion tank.
It should be between the marks on the side of
the tank.
CAUTION
If the engine has been running, pressurized hot
coolant can escape when the radiator cap is
removed and cause burns.
1. Expansion Tank
2. If coolant level is low, remove the expansion
tank cap and replenish the system. DO NOT
OVERFILL.
3. Install the expansion tank cap.
FILL THE FUEL TANK
1. Remove the fuel tank cap.
2. Fill the tank to about 2.5 cm (one inch) below
the top of the tank, not the filler neck, with No.
2 diesel fuel. Then install the cap.
Figure 3
11