Controls - Toro 03530 Operator's Manual

Controls

Seat (Fig. 9)—The seat adjusting lever allows 10 cm
(4 inches) fore and aft adjustment. The seat adjust-
ing knob adjusts the seat for operators' weight. To
adjust the seat fore and aft, pull lever on the left side
of the seat assembly outward. After moving the seat
to the desired location, release the lever to lock the
seat into position. To adjust for the operator's
weight, turn spring tension knob—clockwise to
increase tension, counterclockwise to decrease
spring tension.
1. Seat adjusting level
Traction Pedal (Fig. 10)—Controls forward and
reverse operation. Depress the top of the pedal to
move forward and bottom to move backward.
Ground speed depends on how far the pedal is
depressed. For no load, maximum ground speed, fully
depress the pedal while throttle is in FAST. To stop,
reduce foot pressure on traction pedal and allow it to
return to center position.
Traction Speed Limiter (Fig.10)—Preset this lever
to limit the amount the traction pedal can be
depressed in the forward direction to maintain a con-
stant mowing speed.
Lower Mow / Raise Control Lever (Fig. 11)—The
lever raises and lowers the cutting units and also
starts and stops the reels.
Speedometer (Fig. 11)—Indicates ground speed at
which the machine is traveling.
Fuel Gauge (Fig. 11)—Shows the amount of fuel in
the tank.
Figure 9
2. Seat adjusting knob
Engine Oil Pressure Warning Light (Fig. 11)—
Indicates dangerously low engine oil pressure.
Figure 10
1. Traction pedal
2. Traction speed limiter
3. Reel control light
Engine Coolant Temperature Warning Light (Fig.
11)—The light illuminates and the engine shuts
down if the coolant reaches a dangerously high tem-
perature.
Glow Plug Indicator Light (Fig. 11)—When lit,
indicates glow plugs are on.
1
10
Figure 11
1. Lower Mow/Raise Control Lever
2. Speedometer
3. Fuel Gauge
4. Engine Coolant Temperature Gauge
5. Engine Oil Pressure Warning Light
6. Engine Coolant Temperature Warning Light.
7. Glow Plug Indicator Light
8. Charge Indicator
9. Key Switch
10. Throttle Control
11. Enable/Disable Switch
3
2 5
6
8
7
11
4
9
15