Table of Contents
Advertisement
Electric PTO Clutch Removal
1.
Remove the PTO clutch anchor bolt.
2.
Remove the 4 bolts securing the PTO clutch guard
and remove the guard (Figure 135).
Figure 135
3.
Disconnect the clutch plug.
4.
Use the flats on the washer below the clutch
retaining bolt to hold the crankshaft stationary,
remove the clutch retaining bolt (Figure 136).
Figure 136
Mid-Mount Z Service Manual
ELECTRICAL SYSTEMS
5.
Rotate the clutch assembly until the anchor will
clear the lower clutch guard. Then, slide the
clutch assembly off of the crankshaft while holding
the 2 clutch halves together (Figure 137).
NOTE: On reassembly, torque the 7/16" clutch
1023-011
retaining bolt to
1023-001
Figure 137
???
ft.-lbs.
1023-003
7 - 23
Advertisement
Table of Contents
