R630 Server - Dell PowerEdge R630 Installing Manual

Back view of Dell
No. Item
1 System
Identification Button
2 System
Identification
Connector
3 iDRAC8 Enterprise
Port
4 PCIe Expansion
Card Slot 1 (riser 2)
November 2015
™
PowerEdge
Icon Description
The identification buttons on the front and back panels can be used to
locate a particular system within a rack. When one of these buttons is
pressed, the LCD panel on the front and the system status indicator on
the back blink until one of the buttons are pressed again.
Press to toggle the system ID on and off. If the system stops responding
during POST, press and hold the system ID button for more than five
seconds to enter BIOS progress mode.
If you are directed by services to reset the iDRAC port, press and hold
the button for more than 15 seconds.
Allows you to connect the optional system status indicator assembly
through the optional cable management arm.
Dedicated management port.
Note:
The port is available for iDRAC8 Express features only. Avaya
systems do not come with an Enterprise license. (Not normally used
in Avaya systems.)
Allows you to connect a low profile PCIe expansion card.
Note:
If your server is equipped with 6 or 8 NIC ports this slot can contain
two port 10/100/1000 Mbps NIC connectors or two 100 Mbps/
1Gbps/10 Gbps SFP + connectors, 2 CPUs must be installed for
this slot to be available for use.
Installing the Dell PowerEdge R630 Server
Comments on this document? infodev@avaya.com
Back view of Dell
™

R630 Server

™ ™
PowerEdge R630 Server
Table continues...
11