Setup; Inspection; Cutting Unit Kickstand; Figure - Toro 03681 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
Media and Additional Parts
Description
Parts catalog
Operator's Manual
Certificate of Compliance
Note: Determine the left and right sides of the machine
from the normal operating position.
1

Inspection

Parts needed for this procedure:
1 Cutting unit
Procedure
After the cutting unit is removed from the box, inspect
the following:
1. Check each end of the reel for grease. Grease should
be visibly evident in the reel bearings and internal
splines of the reel shaft.
2. Ensure that all nuts and bolts are securely tightened.
3. Make sure the carrier frame suspension operates
freely and does not bind when moved back and forth.
Description
Cutting unit
No parts required
No parts required
No parts required
Qty.
1
–
–
–
Qty.
1
1 Review the material and save in an appropriate place:
1
2

Cutting Unit Kickstand

No Parts Required
Procedure
Whenever the cutting unit has to be tipped to expose the
bedknife/reel, prop up the rear of the cutting unit with
the kickstand (supplied with the traction unit) to make
sure the nuts on the back end of the bedbar adjusting
screws are not resting on the work surface (Figure 3).
4
Use
Inspect the cutting unit
Use the kickstand when tipping the
cutting unit
Adjust the rear shield
Mount the counter weights
Use