Installing The Ce Decal; Installing Rear Weight - Toro 30555 Operator's Manual

Figure 8
1. PTO guard
4. Slide the PTO shaft guard onto the PTO shaft,
positioning the guard as shown in Figure 8.
5. Slide the male PTO shaft into the female PTO shaft.
Align the gear case input shaft with the PTO shaft and
slide them together. Secure them with the roll pin and
tighten the bolts and locknuts.
6. Attach the PTO shaft guard to the gear box with the 2
bolts and lock washers previously removed.
7. Lower the carrier frame and install 4 clevis pins
through the desired height-of-cut bracket holes and
frame brackets. Secure all 4 pins with hairpin cotters
(Figure 9).
Note: On the GM 3280-D and 3320 the engine must
be started to lower the carrier frame.
Figure 9
1. 25 mm (1 inch)
2. 38 mm (1-1/2 inches)
3. 51 mm (2 inches)
4. 64 mm (2-1/2 inches)
5. 76 mm (3 inches)
8. Check to make sure that the front height-of-cut pins are
resting properly on the frame cushions (Figure 10). If
2. Gear box
6. 89 mm (3-1/2 inches)
7. 102 mm (4 inches )
8. Grass deflector
9. Spring hinges
the pins are not resting properly, place a shim or shims
under the cushion to raise it for proper alignment.
1. Frame cushions
4

Installing the CE Decal

Parts needed for this procedure:
1 Decal
Procedure
Apply the deal to the cutting unit for CE compliance
5

Installing Rear Weight

No Parts Required
Procedure
Two Wheel Drive Groundsmaster 200 Series, 3280-D, and
3320 traction units comply with the ANSI B71.4-2004
Standard when equipped with rear weight. Refer to the
chart in the traction unit Operator's Manual to determine the
combinations of weight required. Order the parts from your
local Authorized Toro Distributor.
Four Wheel Drive Groundsmaster 200 Series and 3280-D
traction units do not need additional rear weight to comply
with the ANSI B71.4-2004 Standard.
11
Figure 10