Lubricating The Caster And Wheel Bearings; Greasing The Transmission; Couplers; Greasing The Pto Drive Belt Idler And Deck Belt Idler - Toro 30319 Operator's Manual

Mid-size, t-bar, gear, 15hp with 52 in side-discharge mower

Hide thumbs Also See for 30319:

Table of Contents

4. Connect a grease gun to the ﬁtting. Pump

grease into the ﬁttings until grease begins to

ooze out of the bearings.

5. Wipe up any excess grease.

Lubricating the Caster and

Wheel Bearings

1. Lubricate the front wheel bearings and front

spindles (Figure 29).

2. Raise the rear of the machine and use jack

stands to support the machine.

3. Remove the rear wheel and tire assembly.

4. Remove rear wheel grease cap. Lubricate the

rear wheel bearing (Figure 29).

5. Install the grease cap.

6. Install the rear wheel and tire assembly.

Note: Make sure the rear wheel grease caps

are removed before lubricating rear wheels.

Figure 29

Lubricate the transmission couplers located in the

back of the machine (Figure 30).

Figure 30

Greasing the PTO Drive Belt

Idler and Deck Belt Idler

Grease the ﬁtting on the PTO belt idler arm pivot

(Figure 31).

Note: You will have to remove the carrier covers

to access the grease ﬁtting for the deck.

Figure 31

Foam element: Clean and re-oil after every 25

operating hours.

Table of Contents