Amana NFW5800DW Use & Care Manual page 11

WASHER CARE (cont.)
Cleaning the Dispensers
After a period of using your washer, you may find some
residue buildup in the washer's dispensers. To remove
residue from the dispensers, remove the drawer and wipe
the surfaces with an affresh® Machine Cleaning Wipe or a
damp cloth and towel dry either before or after you run the
affresh Washer Cleaner cycle. Use an all-purpose surface
®
cleaner, if needed.
IMPORTANT: Dispenser is not dishwasher safe.
Cleaning the Outside of the Washer
Use an affresh® Machine Cleaning Wipe, a soft, damp cloth
or sponge to clean up any spills. Occasionally wipe the
outside of your washer to help keep it looking new. Use an
affresh® Machine Cleaning Wipe or mild soap and water.
IMPORTANT: To avoid damaging the washer's finish, do not
use abrasive products.
Cleaning the Precision Dispense Ultra Cartridge/Load &
Go™ Cartridge/Optimal Dispense Cartridge
It is recommended that you rinse out the Precision
Dispense Ultra cartridge when changing detergent types
or concentrations, or when the washer will not be used for
an extended period.
1. Pull dispenser out until it stops.
2. Lift out the Precision Dispense Ultra cartridge.
3. Lift cover on cartridge and wipe out interior with an
affresh® Machine Cleaning Wipe or a damp cloth and
flush interior thoroughly with warm water.
4. Allow to air dry or wipe with a clean, soft towel.
IMPORTANT: Cartridge is not dishwasher safe.
CLEAN WASHER CYCLE REMINDER
NOTE: Not all models have the Clean Washer with affresh
cycle reminder light.
The Clean Washer with affresh
flash at the end of a wash cycle when
the washer has run 30 wash cycles.
This is a reminder to run the Clean
Washer with affresh cycle.
®
If the Clean Washer with affresh
LED will stop flashing at the end of a wash cycle after running
3 more regular wash cycles. After 30 more wash cycles are
completed, the Clean Washer with affresh
flash at the end of a wash cycle as a reminder.
LED will
®
cycle is not turned on, the
®
LED will again
®
REMOVING THE DISPENSER
To remove:
1. Pull dispenser drawer out until it stops.
2. Press down on the release tab and pull straight out to
remove the dispenser.
3. Lift off cover panel by
pulling straight up.
To replace:
1. Slide cover panel back onto
®
posts on dispenser.
2. Align edges of dispenser
with guides in washer,
then slide dispenser
back into slot.
11